Booting is the process of starting a computer.
0
votes
1answer
18 views
Raspbmc boot failure on fresh install
My Raspbmc-based media centre has been running happily for a couple of months, undisturbed. It's not on constantly; I don't have enough power sockets for the TV, stereo, RPi and games consoles, so I ...
0
votes
1answer
72 views
Pi Not starting up, no light
So my pi is not starting up. None of the lights go on. I've searched online for similar problems but couldn't find anything.
HOW IT HAPPENED:
I was controlling my pi with my laptop using PuTTY. ...
2
votes
2answers
67 views
Can the raspberry boot to an LVM root partition?
Before I start, I will say I have posted this on the Rpi forum as well. I don't normally cross-post but, having tried there and got nothing, I've come to my preferred knowledge centre.
I'm just ...
6
votes
1answer
324 views
Level of Hackability of raspberry pi
I have been working with embedded systems (mostly micro controllers) for about 3 years. I want to know how much of RPi of actually open source?? I know arduino gives us complete details of hardware ...
5
votes
1answer
108 views
CEC wake up command
When I boot my Raspberry my TV gets woken up over CEC.
Is there a way to send the wake up signal using shell so I could use cronjob to start my TV every morning at 7, for example?
0
votes
1answer
36 views
Location of berryboot's config.txt
Related to another question I've asked earlier:
Where is the berryboot's 'config.txt' physically located on the raspberry pi? And how would I access it via command line or similar?
1
vote
1answer
49 views
Raspberry Pi boot stops right after the rainbow splash screen
My R-PI has been working fine for the past 5 days in a row with the official Soft-float Debian "wheezy", it was hard powered off by removing the plug from the wall, now the boot stops at the screen ...
1
vote
0answers
17 views
Prevent Iceweasel opening multiple tabs on startup
I have Iceweasel running on startup. This was setup up by copying the iceweasel.desktop file from applications to ~/.config/autostart/.
I want Iceweasel to open a specific page on startup but not ...
0
votes
1answer
26 views
USB RootFS Problems
I've got another puzzle for you.
I've recently switched my Pi so that it boots on the SD card, and runs root on a USB Disk.
Problem is, when I switched the cmdline.txt to search for the USB drive ...
0
votes
1answer
46 views
how to automatically boot to desktop mode [duplicate]
i accidentally selected the option of booting to terminal during the initial configuration, now i have to type startx to get the desktop environment, how can i get it to boot to desktop GUI ...
-1
votes
1answer
73 views
How to set up the Raspberry Pi [closed]
I have just gotten my Raspberry Pi. I am a beginner in Linux.
Can someone please explain how I should go about starting up my computer?
1
vote
2answers
41 views
U-BOOT and tftp (network) crashes or blocks during uImage download
I installed a u-boot.bin on my boot-parition and adapted everything to make it work and boot the kernel over tftp.
I'm using the current (6709570c) revision from here (Gonzo) and followed the wiki on ...
1
vote
2answers
67 views
cmdline is not working
I'm using a SD-card with raspian (with /boot-partition + the rootfs). I compiled my own kernel and now I would like to boot with nfsroot.
I've added the following line into the cmdline.txt:
...
2
votes
1answer
76 views
USB hub errors on boot
Whenever I boot up my pi, before the login screen arrives, I get an error like the following (listed intermittently among other boot loggings):
hub 1-1:1.0: cannot disable port 3 (err=-110)
over ...
7
votes
3answers
600 views
How do I turn on my Raspberry Pi after shutdown?
My Raspberry Pi runs OpenELEC. The XBMC has a Power-button in the left-bottom corner where I can shutdown the Raspberry Pi. That works fine, but I can't figure out how to turn it on again after the ...
