The pulse tag has no wiki summary.
6
votes
4answers
197 views
Time of flight difference in hardware
I have an ultrasonic emitter, and two ultrasonic receivers. When the emitter emits a pulse, the receivers get the signal at different times. I am only interested in the difference between the two ...
3
votes
2answers
110 views
arduino pulse to transistor power maximum
Hello I want to get a confirmation that what I am doing is not going to fry my Arduino Mega.
The sketch I am using to send a pulse out on pin 8 to a 2n3055 that is switching 12 volts is this:
...
1
vote
1answer
165 views
Generate DC pulse after switch turned off?
I've got a power source (say 12V DC) that I'm monitoring with a relay. I want to send a pulse (over 5V DC) to another relay for 60 seconds after the first power source has been turned off.
A ...
1
vote
2answers
266 views
P-Channel Depletion Mode MOSFET for Negative Pulses
Would a p-channel depletion mode MOSFET make the most sense if the goal is to produce a high-voltage negative square pulse?
My reasoning:
MOSFET, because we're talking about a kV square pulse with ...
1
vote
0answers
28 views
Why do my outputs look exactly the same for the Allegro 3901?
I am trying to capture results shown in Figure 8 of Allegro 3901 data sheet .
My circuit looks like this:
The channels above coresspond to the oscilloscope screen captures below:
In the image ...
0
votes
1answer
119 views
High power pulse generator
I'm designing a relatively high power pulse generator.
Basically I have a microcontroller generating a clean square wave (0-3.3 V or 0-5 V) which then goes into my amplification circuitry. I want to ...
0
votes
1answer
236 views
Arduino beacon for IR Seeker v2 (Mindstorms NXT Sensor) - Pulse IR at 38Khz Carrier and 1200 Frequency
I hate to ask a question like this, that is kinda just like "give me the code" but seriously. I've tried reading up on it everywhere, and I just don't seem to get a thing of having both a carrier ...
-2
votes
1answer
77 views
microcontroller for heart rate meter [closed]
I have pulse meter which gives only filtered signal. I think it's form doesn't need explanations (periodic beats).
I need some microcontroller 3-5V, which would switch scheme (sensor) on, collect ...
