All Questions
3 questions
0
votes
1
answer
444
views
Charging board for 3 battery 3.6V used for supply an Arduino board
I would like to build an autonomous system that contains:
- An Arduino board (later, it will be just the chip)
- A LED strip
I decided to use 3x3.6V lithium batteries in series. So, the idea is to ...
- 1
2
votes
1
answer
671
views
Isolation between cells for battery charging & testing
I want to charge Lipo battery packs and possibly other chemistries too. Six cell packs for starters. But hope to handle more and less. Perhaps a lot more cells. For electric vehicles, skateboards, ...
- 31
0
votes
1
answer
777
views
Li-Po shield for Arduino with in-line recharging, soft-off and voltage protection?
I'm looking for a shield for my Arduino (or a breakout board that I can adapt for the purpose). It should have these abilities:
JST connector for my single-cell battery.
Over- and Under-current ...
- 361