The speed tag has no wiki summary.
1
vote
1answer
140 views
Full-Duplex and Speed negotiation
I have a server where speed and duplex are set to auto. The NIC supports 1000mb/s, and is connected to my Cisco switch.
When I check on port I see that the speed is set to 100Mb/s and Full Duplex.
...
-1
votes
2answers
116 views
speed/duplex mismatch between 1000Mb and 100Mb full duplex
need your thoughts on this, i have a switch that runs on 1000mb Full duplex and a firewall with 100Mb Full duplex, is there a possibility traffic wont pass through?
1
vote
1answer
178 views
Find negotiated speed on Cisco router
I am a bit lost. I'm trying to find the physical interface speed that is negotiated on a Gigabit interface on a Cisco 2900 and 3900 series ISR G2.
On a switch, I am used to giving sh interfaces ...
9
votes
2answers
187 views
Ultra-Fast Querying Using UDP Packets
I am implementing a system where one device on a network queries at a very high frequency (hundreds or thousands of queries per second) through sending a small UDP packet with 8 or so bytes of data. ...
10
votes
4answers
255 views
Do faster segments of a network mean faster flow rate or lower latency?
This is another one of those hypothetical questions. I've been trying to figure out whether or not having a faster 'segment' of a network in between host A and host B will translate into a faster flow ...
6
votes
6answers
250 views
Accurate strategy for measuring point-to-point link performance?
I have a requirement to provide an accurate means to demonstrate line performance over a flat layer2 1Gb point-to-point Ethernet circuit, approx 100 miles apart that seemingly goes through a number of ...
