MPL Parameter Configuration Option for DHCPv6
draft-doi-roll-mpl-parameter-configuration-05

This Internet-Draft is no longer active. Unofficial copies of old Internet-Drafts can be found here:
http://tools.ietf.org/id/draft-doi-roll-mpl-parameter-configuration

Abstract

This draft defines a way to configure MPL parameter set via DHCPv6 option. MPL has a set of parameters to control its behavior, and the parameter set is often configured as a network-wide parameter because the parameter set should be identical for each MPL forwarder in an MPL domain. Using the MPL Parameter Configuration Option defined in this document, a network can be configured with a single set of MPL parameter easily.

Authors

Yusuke Doi <[email protected]>
Matthew Gillmore <[email protected]>

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid)