The PR is #4008

Last time I tried to get this working, the issue was with getting python.d
to properly load the Yoctopuce modules. As far as I could tell at the time, the dynamic import thing works, it's just an issue with getting Python to properly import modules that aren't in system.path, but I didn't look very deep beyond that. Part of the problem there is that the Yoctopuce Python

Next line returns 200 as status https://github.com/Kong/kong/blob/c817fada7a514d84f6e0aab7461605c71bf3a841/kong/plugins/cors/handler.lua#L13

Internet says it should return 204:

• https://developer.mozilla.org/en-US/docs/Glossary/Preflight_request
• https://docs.microsoft.com/en-us/aspnet/core/security/cors?view=aspnetcore-3.1#preflight-requests

Internet changed its mind since 2018 https://

必须先将通过STable创建的表先删除，然后才能删除超级表。当级联表很多时就麻烦了，除非写代码来删除。

The uncompensated temperature of the BMP180 is incorrectly converted to a 16-bit signed value, instead of a 32-bit signed value (long). Since the data is 16-bits wide and can therefore not be negative, the easy fix would be to do the following:

sip.js(1128): uncompensated = uint16(data[0], data[1]);

Please see page 15 of the manual of the BMP180 chip:
https://ae-bst.resource.bosch.com/media

Expected Behavior

Better control over GAIN for LimeSDR device (not mini).
Please use example of the SDR Console Gain Control.

Actual Behavior

Signal really weak on the low frequencies even if GAIN is maximized.

Steps To Reproduce

1. Go to URH
2. Click on Spectrum Analyzer
3. Refresh device, select sampling rate to 2.5M and Gain to above middle point (also tested maxim

Summary of Problem

Not able to open port with stopbits as 1.5

I am currently building a desktop client using electron, where the COM port receives data correctly for values: baudRate: 2400, dataBits: 7, stopBits: 1.5, parity: 'none'

I found from the node-serialport documentation, stopBits Must be one of these: 1 or 2. But, should 1.5 be supported as well? especially for old & slow

I recently installed the microk8s snap on a vanilla LXD container. At the time I hadn't come across https://microk8s.io/docs/lxd and it took a little while before I noticed that some components hadn't started up properly and I found my way to that doc.

Having found the documentation, it's excellent, thank you - following the instructions there left me with a very happy microk8s instance. From a

Is your enhancement proposal related to a problem? Please describe.
Syscalls run on fixed-sized privilege elevation stacks. There is a hard limit on how much stack space a system call can use because of this. We don't have good data on how much stack syscalls actually use.

Describe the solution you'd like
I'd like to be able to use CONFIG_STACK_USAGE to be able to generate a report,

all of these files are ONLY for test cases.