All Questions
Tagged with arduinoisp arduino-pro-mini
3 questions
0
votes
1
answer
7k
views
Yikes! Invalid device signature. Fail to burn bootloader and read fuses
I know this problem is kinda common but I had to post it anyway.
Before anything, I would like to inform you guys that I changed the fuse of my Arduino Pro 3v3 @ 8MHz to allow 1.8 V brownout and also ...
2
votes
1
answer
697
views
Arduino Pro Mini lower BOD problem
I am planing to build a project where an arduino pro mini 3.3V runs on 2 aa batteries. The standard brown out detection shuts it down at about 2.7/2.8V where it could run on lower voltages too.
So I ...
- 133
9
votes
1
answer
8k
views
Problem programming Mini Pro via Arduino as ISP
I just picked up a pair of Arduino Mini Pro 5v clone boards (Inland, sold at Microcenter, currently $4 USD) and I wanted to use my Uno as an ISP like I've done with ATmega328 and ATtiny85 chips before....
- 286